麻将胡了官方网站入口

Polytek silicone rubber was tested in an independent laboratory and found to comply with 21 CFR 177.2600 (Federal Regulations) for rubber products with reusable food contact surfaces that have been accurately measured, thoroughly mixed, and fully utilized



Cooking or food processing applications include:

Candy mold, gummy mold, CBD or THC gummy mold
Ice mold and tray chocolate mold butter mold
Cake decoration and gummy mold
Gaskets and seals for food processing environments


Advantages of Polytek silicone rubber:

Silicone resin molds can provide non stick demolding performance and dimensional stability for many food based casting media, and can accurately allocate dispensing amounts
Easy to clean, correctly constructed, and maintained molds have a long lifespan




Handling method:

View the technical announcements of each product for processing instructions. Before using silicone molds or parts for food, thoroughly clean the molds or parts with water and dishwashing detergent solution, rinse and air dry. If applicable, thoroughly clean the mold or parts between batches. If baking, do not expose the mold to temperatures above 400 ° F.

*Compliance with this regulation does not mean that these silicone rubbers have been approved by the FDA - users of these materials must also comply with all applicable FDA requirements. Adding additives (such as colored pigments) can create untested conditions, so it is not possible to make a statement about their compliance with the FDA.



Amazing Smelt is a non-toxic, reusable mold manufacturing material used for room temperature or low heat release materials.

The astonishing remelting temperature softens at 120 ° F and becomes liquid at 135 ° -140 ° F. Re melt in an oven, microwave, or double pot hot melt furnace. It can be remelted and reused to manufacture new molds again and again.

Very suitable for making molds for smaller items such as jewelry, embellishments, push molds for polymer clay, resin molds, or food molds such as chocolate, ice, gelatin, and gummies.

Remelt meets FDA standards for food contact.

The following silicone rubber molds have been evaluated and tested by the FDA (FDA 21 CFR 177.2600)

Amazing Mold Putt: 1A:1B
Yellow paste mold silicone rubber, cured in 20 minutes/hardness A25, commonly used in food/jewelry and teaching.

Amazing Remelt
single-component
Non toxic, reusable red paste like special mold material, heated to 60 ℃ for liquefaction